Tag Archives: Electrical

Door, Electrics, School Bus, school bus RV, Skoolie

Replacing a Linear Actuator

Leave a comment

So, you may remember that I removed a section of the bar that opens the manual door and replaced it with a linear actuator, which was then attached to a remote unit that meant that the door could be opened and closed by the use of a remote fob.  And the system worked really nicely for a couple of years.

Unfortunately, it was subjected to stresses that I hadn’t foreseen.  While I had looked at the 300 lb holding ability, and the 8 lb press (not 150, I came to find out – a labeling error) power as sufficient, I hadn’t prepared for a teenager who was trying to pull closed the accordion door while the hand-control was locked closed.  The back plate of the actuator snapped under the stress.

Faced with this situation, I obviously had to fix this, so that the door could be closed and secured, but still usable.  As a temporary solution, I had a piece of 2×10 that just fit in the bottom stair that would block the door from opening, and I could still climb in and out of the rear door which has the deadbolt lock.  I then set about trying to find a replacement plate.

Firgelli Automations no longer made the model that I had purchased, so had no parts for it available.  I then attempted to fab up a ‘sheath’ to enclose the back and secure the engine/shaft casing.  As I was finishing this up, the engine finally failed, which was very frustrating.  As I did some research, I found that many of this model had had the engine fail, and it was a usual end-of-life situation for it.

While this was disheartening, I contacted Firgelli’s support about getting specs on the engine to see if I could find a replacement somewhere, but no luck.  They make all their components themselves, so it was a special run.  They were able to point me toward a different model that was more rugged and had a more powerful (and durable) engine than the model I had.

This model is much more rugged than the original unit, and about twice as powerful.  And the connectors are an eighth of an inch bigger in diameter than the original, which meant that not only did I have to undo all my sheathing welding, but I had to fabricate new sockets too.  As we were right near the limit of when the inspection for the bus would run out, they’re, unfortunately, rough and unpainted.

It’s also an inch longer when fully retracted, and I was able to compensate for about 1/2 an inch with the adjustment threads at the door, but it means that the door doesn’t open quite as wide as the old unit allowed – but that’s just me being picky.  (It’s also cheaper to buy directly from the company’s site than through Amazon …)

While I’ve not got to painting the new unit, I do have to admit that the works are much smoother than the old unit. Check it out in action:

batteries, bus trouble, camping, Destination, driving, Electrics, Evangola, horns, Presque Isle, school bus RV, Skoolie, trip

A Trip to Presque Isle State Park, PA

Leave a comment

So, on the 13th of July we set out for Presque Isle State Park in/by Erie, PA.  Our son had a day’s worth of homeschool classes on aquaculture, swamp & beach biomes, the geology of the park, and preservation and maintenance of the park.  While it was only two and a quarter hours away from Buffalo, as the classes started at 9 am, we decided to camp overnight.

Our trip was uneventful, except for the fact that I made the mistake of topping up the coolant level in the bus before we left.  Why was this a problem?  Because there was a small leak at the coolant reservoir that dripped down onto the alternator, frying the voltage regulator.  By the time we had hit the Angola Rest Area on the NYS Thruway/I-90, we were running on battery power.  But as on our Evangola trip, I knew that the engine would keep running fine, but unlike that previous trip I had the house batteries fully charged, and chargers for both the house and bus batteries that would work when we got to shore power.  But now I knew the reason WHY the alternator was failing.  Unfortunately, the fluctuations in voltage damaged the board in the fridge, though I got it to work for part of the time we were plugged in.

We stayed at Sara’s Campground, whose lands abut right up to both the Presque Isle State Park and the Tom Ridge Environmental Center.  Their grounds also have sites on both sides of Peninsula Drive/Route 832, the east side has sites for actual beach camping (in tents), and the west side is in the more forested area.

Sara's Campground Site Map
Sara’s Campground Site Map

So, we ended up getting Site 21 in the Forest Section.  It was our first stay in a private campground, and I was frankly surprised at the density of sites! The dashcam recorded our trip into our site, including the trepidation and worries I had of getting the bus in a place I’d have to back out of.

Sara’s Campground, Site 21, with the bus all settled.

But the site was fine.  The electric/water pole had a streetlight on it, so we had to put a blanket up over the windows on that side (thankfully magnets hold to bus steel wonderfully).  But there were no sites to our starboard side (where the firepit was), so it was a nice open site (next to a parking lot). And the concrete pad was very nicely level, so everything was comfortable.

Saras Campground, Site 21, with the bus settled and the fire burning down for Toastites.
Saras Campground, Site 21, with the bus settled and the fire burning down for Toastites.

But right across the street (via a crosswalk with speedbumps and a pushbutton controlled set of flashing lights to cross) was the start of Presque Isle’s beaches, and we walked all the way up past the first couple of breakwaters.  We did a little beachcombing, then returned and we made a fire and some lovely toastites for dinner.  We had some people stop by, interested in the bus, and we gave them the tour, and some skoolie info, as they had expressed interest in working up their own.

The sunset over lake Erie, shining right through the back window of the bus.
The sunset over lake Erie, shining right through the back window of the bus.

A little while later, as the sun was setting, we found that the sun was setting directly behind the bus, through the path to the beach.  It was, however, it was basically 9pm, so we were forced to get to bed before we felt we were ready.

Our next morning was fine, coffee and bowls of cereal for breakfast, and as the engine was running and I was doing our pre-trip, folks came over, interested in the bus. Alas, we didn’t have time for a tour, and weren’t returning, but they thought the concept was cool and were absolutely fine with us being there.

Unfortunately, given the short timing of us getting to the Tom Ridge Center for the aquaponics class, and then us getting from that class to our pontoon boat tour, I forgot to turn the dashcam on for those trips. But after the boat tour, I remembered to turn the cam on, so we have a video tour of Presque Isle, sped up 4x.  You miss out on a whole bunch of the cottonwood tree seeds floating about at that speed, but I recorded us getting from the tour to Barracks Beach, and then down the beach road to the Tom Ridge Center again, and then around the whole park once more.

 

Our trip back was uneventful, except for the one tractor-trailer driver who LOVED the train horn.  He paced us while we were still in PA, blew his horn and motioned for me to blow ours and gave a thumbs-up when I did, and hung out in front of us to break air for us until he got to the Angola, NY exit where he sounded his horn again and waved, and I sounded ours again.

Allegany State Park, Electrics, learning, RV oven, RV stove, school bus RV, Skoolie, trip

A Week in the Bus (Allegany State Park trip – Part II)

2 Comments

(Continued from Part I)

After arriving around midnight at the campsite, we set up the basics, and got to bed. My wife and I ran into a bit of a problem with our bed situation, as the air mattress we had been using had developed a leak that I couldn’t patch, and the replacement we brought was a king-sized one that wouldn’t fit in the back area. Luckily, with just the three of us in the bus, we could share the bottom bunk, while our son took the top bunk.

We had a nice site near the top of the hill on our loop. For the Red House camping area, the A loop and B loop had their own bathroom facilities, while the C and D shared a bathroom, I think with the E loop. There were abundant water taps, and fairly nice stone rings for firepits, though no grates. We realized that we’d been spoiled, as the fire pits and rings at Sprague Brook and Evangola had attached and adjustable grates to cook on.

Luckily, the camp store was literally down the hill and across the road from our site, and they had a nice round grating that I could perch on stones in our firepit and make a cooking surface. They also sold a 30amp to 15amp plug adapter, which I found I needed, as the 15amp power plug on the power tree was a GFCI outlet that kept tripping when I plugged into it (which of course was happening after midnight in the light rain.)  

I was totally perplexed as to what was tripping the outlet, as the system worked fine on my garage’s 15amp breaker, so after going through everything and eventually unplugging a number of non-essential systems including the plug from the inverter (even though the breaker for the inverter’s power feed was off), I finally got us basic power for lights and the fridge. After spending part of the morning tearing apart the main power in plug and the breaker box, I found that it seemed that the GFCI was being tripped by the ground of the plug of the inverter.

As the ‘main’ of the box is just a regular breaker, I had wired in the plug end of a 12 gauge extension cord into an unused breaker in the box, with the understanding that in order to power the system with the inverter, I would first turn off the main, then turn on the inverter breaker, and to go back to land power, the inverter breaker would go off first, then the main would go on. But as the inverter was set to take a grounded plug, but only connected to the 12VDC positive and negative, it seemed that the GFCI ‘saw’ the system with a return/ground fault in the 110AC system. Once I put the adapter in and plugged into the 30amp outlet, there was no issue, and all worked the way it was supposed to.

We finally got to use the stove, and it preformed admirably. While most of our cooking was done over the wood fire, the burners of the stove did a nice job with popcorn, and the oven did a great job with flatbread pizzas (and a 12” round fits easily). However, I’ve found that I need some small receptacle for spent matches, though I’m realizing that all those ashtrays that have fallen into disuse should provide for something both suitable and attractive.

The troubleshooting/improving never stops …

 

(More on the park in Part III)